Knowing depth to bedrock is essential for designing piles and foundations, planning excavations and quarries, and siting dams and tunnels. Drilling boreholes everywhere is expensive. Seismic methods map bedrock continuously between boreholes. This article compares the main techniques.
Why bedrock depth matters
- Piles: length and cost depend on where competent rock is.
- Excavations: rock requires breaking or blasting, changing cost and programme.
- Foundations: variable rockhead can cause differential settlement.
- Dams and tunnels: bedrock depth and quality control design and seepage.
Seismic refraction
Seismic refraction measures P-wave velocities and refractor depths. Bedrock usually has much higher velocity than overlying soil, making it a strong refractor. Tomographic inversion maps an irregular rockhead and weathering profile along the line.
- Strengths: well established, gives velocities for rippability.
- Limitations: the water table can appear as a refractor at about 1,500 m/s; velocity inversions are not detected.
MASW
MASW measures shear-wave velocity, which increases sharply at bedrock. Because Vs is not dominated by groundwater, MASW helps distinguish the water table from rock.
- Strengths: stiffness information, works in noisy areas.
- Limitations: active MASW usually reaches about 20 to 30 m; resolution decreases with depth.
Passive HVSR (H/V spectral ratio)
A single three-component sensor records ambient vibrations. The ratio of horizontal to vertical motion shows a peak at the site’s resonant frequency (f0). Where soil overlies much stiffer bedrock, depth can be estimated from:
H ≈ Vs / (4 × f0)
where Vs is the average soil shear-wave velocity.
- Strengths: quick, cheap, can estimate deep bedrock.
- Limitations: needs a strong stiffness contrast and a reliable Vs value, often from MASW.
Combining methods
A practical approach on many sites:
- Drill a few boreholes to prove rock and calibrate velocities.
- Run refraction or MASW lines across the site.
- Use HVSR points to fill gaps or estimate deeper rock.
- Build a rockhead contour map and check against boreholes.
See integrating geophysics and borehole drilling.
Non-seismic alternatives
ERT also maps bedrock where resistivity contrast is strong, such as clay over granite. GPR can map very shallow rock in resistive ground. Choosing the method depends on site conditions.
Common pitfalls
- Mistaking the water table for rock on refraction.
- Boulders or hard layers above weaker material being taken as bedrock.
- Weathered transition zones with gradually increasing velocity.
Rock coring to confirm rock quality avoids these errors. See rock core logging.
How Quantum Geoconsultants can help
We map depth to bedrock with refraction, MASW and HVSR, calibrated by our drilling. See seismic refraction surveys, MASW and geotechnical surveys.
Frequently asked questions
Why is depth to bedrock important?
It controls foundation and pile design, excavation cost and method, quarry planning and the design of dams and tunnels.
Which method is best for depth to bedrock?
Seismic refraction is the classic method. MASW adds stiffness information, and passive HVSR can estimate deeper bedrock. Combining methods with boreholes gives the best result.
How accurate are seismic depth estimates?
Typically within about 10 to 20 percent where conditions suit the method, better when calibrated with boreholes.
📡 Request a geophysical survey quote
The cost of a geophysical survey depends mainly on the area or length of survey lines, the methods and depth of investigation needed, and site access. Tell us about your project and we will propose a survey design and quotation.
We reply with a proposed survey design and quotation. Prices are not listed online because every site and target is different.
Plan your geophysical survey
Tell us your site, target and depth of interest. We will recommend the right methods and send a survey design and quotation.