MASW (Multichannel Analysis of Surface Waves) measures how stiff the ground is by recording surface waves. It is fast, non-invasive and gives a continuous shear wave velocity profile, a parameter at the heart of modern geotechnical and seismic design.
The principle
A hammer blow generates surface waves (Rayleigh waves) that travel along the ground. Longer wavelengths penetrate deeper. Because stiffness usually changes with depth, waves of different frequencies travel at different speeds: they are dispersive. By measuring this dispersion, the shear-wave velocity (Vs) of the ground at different depths can be calculated.
Field procedure
- Lay out typically 24 low-frequency geophones (often 4.5 Hz) in a straight line at 1 to 2 m spacing.
- Strike a plate with a sledgehammer at a set offset from the first geophone.
- Record and stack several shots.
- Move the spread along the line for 2D profiles.
Passive MASW records ambient vibrations, such as traffic, to reach greater depths.
Processing
- Transform records into a dispersion image showing phase velocity against frequency.
- Pick the fundamental mode dispersion curve.
- Invert the curve to a layered Vs profile.
- Combine profiles along a line into a 2D Vs section.
Why shear-wave velocity matters
Vs relates directly to the small-strain shear modulus of the ground:
G0 = ρ × Vs²
where ρ is density. G0 is used in settlement analysis, foundation stiffness, dynamic machine foundation design and vibration assessment. Unlike P-wave velocity, Vs is not dominated by groundwater, so it reflects the soil skeleton.
Applications
- Seismic site classification using Vs30. See Vs30 and seismic site classification.
- Ground stiffness for foundations, rafts and high-rise buildings.
- Depth to bedrock and weathering profiles.
- Soft zones and voids beneath roads and slabs.
- Compaction verification of fills and ground improvement.
- Liquefaction screening in loose saturated sands.
Strengths
- Non-invasive, quick and economical.
- Works in noisy urban environments, especially with passive methods.
- Gives continuous profiles between boreholes.
Limitations
- Assumes roughly horizontal layers beneath each spread.
- Resolution decreases with depth.
- Higher modes can be mistaken for the fundamental mode.
- Stiff layers over soft layers make interpretation harder.
Calibration with SPT results and boreholes gives the most reliable results.
How Quantum Geoconsultants can help
We carry out MASW surveys for stiffness, seismic classification and soft zone detection. See MASW surveys in Kenya, geophysics for construction and investigation for high-rise buildings.
Frequently asked questions
What does MASW measure?
MASW measures the dispersion of surface (Rayleigh) waves to calculate a shear-wave velocity profile of the ground with depth.
Why is shear-wave velocity useful?
It is directly related to ground stiffness and is used in seismic site classification and settlement and vibration assessments.
How deep does MASW investigate?
Active MASW typically reaches about 20 to 30 m with a hammer source. Passive methods using ambient noise can reach deeper.
📡 Request a geophysical survey quote
The cost of a geophysical survey depends mainly on the area or length of survey lines, the methods and depth of investigation needed, and site access. Tell us about your project and we will propose a survey design and quotation.
We reply with a proposed survey design and quotation. Prices are not listed online because every site and target is different.
Plan your geophysical survey
Tell us your site, target and depth of interest. We will recommend the right methods and send a survey design and quotation.