Get a Quote
← All articles

Understanding Borehole Yield and Its Importance in Pump Selection

What borehole yield and safe yield mean, how they are measured by test pumping, and why pumps must be sized to the safe yield to avoid dry running and borehole damage.

By Quantum Geoconsultants pump installation teamUpdated 19 November 20262 min read
TopsoilLava flowOlder lavas & tuffsStatic water level (pump off) Pumping water level ◀ Submersible pump & motor ◀ Screen below the pump Pump sized from test pumping

⚙️ Borehole Pumps & Solar: a technical article by the Quantum Geoconsultants pump installation team.

The most common mistake in borehole pumping is installing a pump bigger than the borehole can supply. Understanding borehole yield and safe yield prevents this and protects both the pump and the borehole.

What is yield?

Yield is the rate at which water can be pumped from a borehole, usually in m³/h or litres per hour. A borehole’s yield depends on the aquifer, borehole design and how well it was developed.

Airlift yield versus tested yield

During drilling, contractors often measure an airlift yield. This is only an early indication and can be misleading. The reliable figure comes from a proper pumping test with a submersible pump.

Safe yield

The safe yield is the rate that can be pumped for long periods without:

It is usually lower than the maximum rate achieved during testing, and allows for dry-season declines.

How yield relates to drawdown

Pumping faster lowers the water level more. Step drawdown tests show this relationship, and constant rate tests show whether levels stabilise over time. See step and constant rate tests and water levels and drawdown.

Why yield controls pump choice

For example, a borehole with a safe yield of 2 m³/h can supply about 16 m³ in eight hours of pumping, or more over longer hours with suitable controls and storage.

Low-yield boreholes

Low-yield boreholes can still be very useful with the right design:

Yield changes over time

Yield can decline due to clogging of screens, falling regional water levels or interference from nearby boreholes. Monitoring flow and water levels detects this early. Rehabilitation can often restore lost yield.

Protecting the pump

Dry-run protection, level electrodes and correct controls stop the pump before damage if levels fall unexpectedly. See control panels and protection.

How Quantum Geoconsultants can help

We test boreholes, determine safe yields and size pumps to match. See pump installation, borehole drilling and selecting a submersible pump.

Frequently asked questions

What is borehole yield?

The rate at which a borehole can supply water, usually in cubic metres or litres per hour.

What is safe yield?

The rate a borehole can be pumped over the long term without water levels falling to the pump or causing damage, as determined from pumping tests.

What happens if a pump is too big for the borehole?

It lowers the water level to the pump intake, causing dry running, overheating, sand problems and early pump failure.

⚙️ Borehole pump size calculator

Enter your borehole's numbers from the test pumping report (or your best estimate) to see the total head, the flow and roughly how big a submersible pump or solar array you need.

0total head (m)
0pump flow (m³/hour)
0solar array (watts)

Rough planning figures only. Total head = pumping water level + tank height + an allowance for pipe friction. The final pump is chosen from the manufacturer's pump curves, your test pumping yield and your water quality.

Get a borehole pump installation quote

Send us your test pumping report, borehole depth and where the tank will sit. We will size the right submersible or solar pump and send a quotation for supply, installation and commissioning.

💬 WhatsApp