The control panel is the pump’s brain and bodyguard. It starts and stops the pump, protects it from electrical and hydraulic problems and automates operation. This article explains what a good borehole control panel contains.
Main functions
- Switching the pump on and off
- Protecting the motor from damage
- Automating operation by tank level and time
- Displaying status and faults
Starting methods
- Direct on line (DOL): simple, for smaller motors.
- Star-delta: reduces starting current for larger three-phase motors where suitable.
- Soft starters: ramp voltage to reduce starting stress.
- Variable frequency drives (VFDs): control speed, give soft starts and save energy where demand varies.
Protection devices
Overload protection
Thermal or electronic overload relays trip the motor if current exceeds safe levels.
Dry-run protection
Level electrodes in the borehole, or relays that sense reduced motor load, stop the pump when water is too low. See pump submergence.
Voltage and phase protection
Relays monitor under-voltage, over-voltage, phase loss and phase imbalance, which are common causes of motor failure where supply is unstable.
Surge and lightning protection
Surge protective devices and proper earthing reduce damage from lightning and grid surges, a frequent problem in highland and open areas.
Short-circuit protection
Circuit breakers or fuses protect cables and equipment.
Automatic controls
- Tank float switches or level sensors: start the pump when the tank is low and stop it when full.
- Timers: limit pumping hours or allow recovery of low-yield boreholes.
- Restart delays: wait after a dry-run trip to let water levels recover.
- Pressure switches: for direct pressure supply with a pressure tank.
Monitoring
Modern panels can record run hours, faults, current and voltage, and some send alerts by SMS or internet. Monitoring helps detect problems early and supports maintenance planning.
Solar controllers
Solar pump controllers combine MPPT power management with dry-run, tank level and other protections. See solar controllers and MPPT.
Installation quality
- Weatherproof enclosure suited to the location
- Correct ratings for motor current and supply
- Proper earthing
- Clear labelling and wiring diagrams
How Quantum Geoconsultants can help
We supply and install control panels with full protection. See pump installation and troubleshooting pumping problems.
Frequently asked questions
What is dry-run protection?
A device that stops the pump when the borehole water level falls too low, using level electrodes or by sensing reduced motor load.
Why is voltage protection important in Kenya?
Voltage fluctuations and phase loss can burn out motors. Protection relays stop the pump when supply is outside safe limits.
Can a pump fill a tank automatically?
Yes. Float switches or level sensors in the tank start and stop the pump automatically.
⚙️ Borehole pump size calculator
Enter your borehole's numbers from the test pumping report (or your best estimate) to see the total head, the flow and roughly how big a submersible pump or solar array you need.
Rough planning figures only. Total head = pumping water level + tank height + an allowance for pipe friction. The final pump is chosen from the manufacturer's pump curves, your test pumping yield and your water quality.
Send these numbers on WhatsAppGet a borehole pump installation quote
Send us your test pumping report, borehole depth and where the tank will sit. We will size the right submersible or solar pump and send a quotation for supply, installation and commissioning.