Get a Quote
← All articles

Selecting the Right Submersible Pump for a Borehole

How to select a submersible borehole pump: matching flow and head to the pump curve, borehole diameter, safe yield, power supply, materials and water quality.

By Quantum Geoconsultants pump installation teamUpdated 19 November 20262 min read
TopsoilLava flowOlder lavas & tuffsStatic water level (pump off) Pumping water level ◀ Submersible pump & motor ◀ Screen below the pump Pump sized from test pumping

⚙️ Borehole Pumps & Solar: a technical article by the Quantum Geoconsultants pump installation team.

Choosing a borehole pump is not just about horsepower. The right submersible pump delivers the flow you need at the head your system requires, within what the borehole can safely supply, at good efficiency. This article explains how to choose.

1. Start with the borehole data

See borehole yield and pump selection.

2. Define the duty point

The duty point is the flow you need (m³/h) and the total dynamic head (m) at that flow. Flow should not exceed the safe yield. See TDH and flow rate.

3. Read pump curves

Each pump has a curve showing head against flow. Choose a model whose curve passes through or just above your duty point, ideally close to its best efficiency point. Pumps operating far from this point use more energy and wear faster.

4. Check physical fit

Submersible pumps come in standard diameters, commonly 3, 4 and 6 inches. The casing must allow clearance for the pump, cable and any cooling shroud. A borehole too narrow limits pump choice, which is why borehole design should consider future pumping needs.

5. Match the power supply

Cable size must keep voltage drop within limits over the full cable length.

6. Materials and water quality

7. Motor cooling and setting depth

Submersible motors are cooled by water flowing past them. If the pump must be set below the screens, a cooling shroud directs flow over the motor. See water levels and pump submergence.

8. Think about the whole system

Storage tanks, pressure needs and demand patterns affect the best choice. A smaller pump running longer into a tank is often better than a large pump running briefly. See tank sizing.

Common selection errors

How Quantum Geoconsultants can help

We select pumps using test pumping data and full hydraulic calculations. See borehole pump installation and our complete pump guide.

Frequently asked questions

What size pump do I need?

It depends on the flow you need, the total head and the borehole's safe yield. A pump curve shows whether a model meets that duty point.

Does a 4-inch pump fit a 4-inch borehole?

Usually not. 4-inch pumps typically need casing with an internal diameter somewhat larger than 4 inches to allow for the cable and clearance.

Why does water quality affect pump choice?

Corrosive or sandy water can damage standard pumps. Stainless steel pumps and suitable materials last longer in aggressive water.

⚙️ Borehole pump size calculator

Enter your borehole's numbers from the test pumping report (or your best estimate) to see the total head, the flow and roughly how big a submersible pump or solar array you need.

0total head (m)
0pump flow (m³/hour)
0solar array (watts)

Rough planning figures only. Total head = pumping water level + tank height + an allowance for pipe friction. The final pump is chosen from the manufacturer's pump curves, your test pumping yield and your water quality.

Get a borehole pump installation quote

Send us your test pumping report, borehole depth and where the tank will sit. We will size the right submersible or solar pump and send a quotation for supply, installation and commissioning.

💬 WhatsApp