A borehole is only useful when water reaches the tap. The pump, its power supply and controls form a system that must be matched to the borehole and the user’s needs. This guide explains borehole pump installation from selection to maintenance.
The parts of a pumping system
- Submersible pump and motor installed below the water level
- Rising main pipe carrying water to the surface
- Power cable and safety rope
- Control panel with protection, or a solar controller
- Power source: grid, solar, generator or hybrid
- Headworks: wellhead seal, non-return valve, gauge, flow meter
- Storage tank and distribution pipework
See submersible pump components.
Step 1: Know your borehole
Pump selection starts with the test pumping report: safe yield, static and dynamic water levels, borehole depth, casing diameter and water quality. See borehole yield and pump selection.
Step 2: Work out your demand
Estimate daily water use for people, livestock, irrigation or processes, and peak flow needs. See determining pumping capacity.
Step 3: Calculate total head
Total dynamic head includes lift from the pumping water level, the height to the tank inlet, pipe friction and any pressure needed. See TDH and flow rate.
Step 4: Select the pump
Choose a pump whose performance curve delivers the required flow at the calculated head, ideally near its best efficiency point, without exceeding the borehole’s safe yield. See selecting a submersible pump.
Step 5: Choose the power source
- Grid electricity: reliable where supply is stable.
- Solar: no fuel or bills; ideal for daytime pumping to storage. See solar pumping systems.
- Generator: flexible but costly to run.
- Hybrid: solar plus grid or generator backup.
Step 6: Installation
The pump, rising main, cable and rope are assembled, the cable splice is sealed and tested, and the assembly is lowered to the correct depth and secured. See installation procedures.
Step 7: Commissioning
Flow, pressure, current, voltage and water level are measured and compared with design. See pump testing after installation.
Step 8: Maintenance
Regular monitoring and servicing keep the system efficient and extend pump life. See borehole pump maintenance.
Common mistakes
- Choosing a pump bigger than the borehole can supply
- Setting the pump too shallow or below the screens without a shroud
- Undersized cables causing voltage drop
- No dry-run or voltage protection
- No storage, forcing the pump to start and stop constantly
How Quantum Geoconsultants can help
We size and install borehole pumps and solar systems from test pumping data. See borehole pump installation in Kenya and borehole solar installation.
Frequently asked questions
How do I choose the right borehole pump?
Use the borehole's test pumping results (safe yield and dynamic water level), your daily water demand and the total head to the tank or delivery point.
Should I use solar or electricity?
Solar suits most daytime water needs and removes running costs. Grid or generator power suits high, continuous demand. Hybrid systems combine both.
How long does a borehole pump last?
Typically several years to more than ten, depending on water quality, sand, correct sizing, electrical protection and maintenance.
⚙️ Borehole pump size calculator
Enter your borehole's numbers from the test pumping report (or your best estimate) to see the total head, the flow and roughly how big a submersible pump or solar array you need.
Rough planning figures only. Total head = pumping water level + tank height + an allowance for pipe friction. The final pump is chosen from the manufacturer's pump curves, your test pumping yield and your water quality.
Send these numbers on WhatsAppGet a borehole pump installation quote
Send us your test pumping report, borehole depth and where the tank will sit. We will size the right submersible or solar pump and send a quotation for supply, installation and commissioning.