The most common mistake in borehole pumping is installing a pump bigger than the borehole can supply. Understanding borehole yield and safe yield prevents this and protects both the pump and the borehole.
What is yield?
Yield is the rate at which water can be pumped from a borehole, usually in m³/h or litres per hour. A borehole’s yield depends on the aquifer, borehole design and how well it was developed.
Airlift yield versus tested yield
During drilling, contractors often measure an airlift yield. This is only an early indication and can be misleading. The reliable figure comes from a proper pumping test with a submersible pump.
Safe yield
The safe yield is the rate that can be pumped for long periods without:
- Drawing the water level down to the pump
- Exposing screens to air, which encourages clogging and corrosion
- Pulling in sand or poor-quality water
- Causing long-term declines in water level
It is usually lower than the maximum rate achieved during testing, and allows for dry-season declines.
How yield relates to drawdown
Pumping faster lowers the water level more. Step drawdown tests show this relationship, and constant rate tests show whether levels stabilise over time. See step and constant rate tests and water levels and drawdown.
Why yield controls pump choice
- The pump’s flow at the duty head must not exceed the safe yield.
- The pump must be set below the dynamic level at that rate, with a margin.
- Daily demand is met by pumping hours, not by oversizing the pump.
For example, a borehole with a safe yield of 2 m³/h can supply about 16 m³ in eight hours of pumping, or more over longer hours with suitable controls and storage.
Low-yield boreholes
Low-yield boreholes can still be very useful with the right design:
- Smaller pumps running longer
- Larger storage tanks
- Level controls that stop the pump before it runs dry
- Solar pumping, which naturally spreads pumping across the day
Yield changes over time
Yield can decline due to clogging of screens, falling regional water levels or interference from nearby boreholes. Monitoring flow and water levels detects this early. Rehabilitation can often restore lost yield.
Protecting the pump
Dry-run protection, level electrodes and correct controls stop the pump before damage if levels fall unexpectedly. See control panels and protection.
How Quantum Geoconsultants can help
We test boreholes, determine safe yields and size pumps to match. See pump installation, borehole drilling and selecting a submersible pump.
Frequently asked questions
What is borehole yield?
The rate at which a borehole can supply water, usually in cubic metres or litres per hour.
What is safe yield?
The rate a borehole can be pumped over the long term without water levels falling to the pump or causing damage, as determined from pumping tests.
What happens if a pump is too big for the borehole?
It lowers the water level to the pump intake, causing dry running, overheating, sand problems and early pump failure.
⚙️ Borehole pump size calculator
Enter your borehole's numbers from the test pumping report (or your best estimate) to see the total head, the flow and roughly how big a submersible pump or solar array you need.
Rough planning figures only. Total head = pumping water level + tank height + an allowance for pipe friction. The final pump is chosen from the manufacturer's pump curves, your test pumping yield and your water quality.
Send these numbers on WhatsAppGet a borehole pump installation quote
Send us your test pumping report, borehole depth and where the tank will sit. We will size the right submersible or solar pump and send a quotation for supply, installation and commissioning.