Seismic reflection is the method behind most oil and gas discoveries, including those in Kenya’s Lokichar Basin. At smaller scale, high-resolution shallow reflection also maps geology for groundwater, mining and engineering. This article explains how it works.
The principle
Seismic waves from a source travel into the ground and part of their energy is reflected back wherever there is a change in acoustic impedance (density times velocity), such as a boundary between clay and sandstone or a fault. Receivers at the surface record the reflected arrivals. Their timing and strength reveal the depth and nature of boundaries.
Reflection versus refraction
- Reflection images many boundaries in detail, including low-velocity layers and complex structures.
- Refraction is simpler and cheaper but mainly gives velocities and depths of faster layers.
Acquisition
- Sources: hammers and weight drops for shallow work; vibroseis trucks or explosives for deeper surveys.
- Receivers: many closely spaced geophones, often hundreds or thousands for 2D or 3D surveys.
- Common midpoint (CMP) geometry: many source-receiver pairs sample the same subsurface point, allowing stacking to improve signal.
Processing
- Geometry assignment and quality control
- Filtering to remove noise and surface waves
- Static corrections for elevation and near-surface variation
- Velocity analysis and normal moveout correction
- Stacking to enhance reflections
- Migration to place reflections in their correct positions
- Depth conversion using velocities from boreholes or analysis
Interpretation
Interpreters trace reflectors as layer boundaries, identify faults where reflectors are offset, and recognise features such as channels, folds and unconformities. Borehole data tie reflectors to real geology.
Applications
- Petroleum exploration: mapping basins and traps, as in northern and coastal Kenya.
- Geothermal exploration: mapping faults and structures in the Rift.
- Groundwater: mapping deep aquifers in sedimentary basins.
- Mining: tracing layered deposits such as coal and some ores.
- Engineering: high-resolution shallow surveys for tunnels, dams and fault mapping.
- Marine and lake surveys: sub-bottom profiling for ports and dredging.
Limitations
- More expensive and processing-intensive than other near-surface methods.
- Very shallow targets (a few metres) are difficult to image.
- Complex geology and strong near-surface variation reduce image quality.
- Needs boreholes or other data for depth calibration.
When to choose reflection
Reflection is the right choice when detailed layering and structures at tens to thousands of metres depth are needed, and when other methods cannot resolve them. For shallow engineering problems, refraction, MASW and ERT are usually more economical.
How Quantum Geoconsultants can help
We advise on survey method selection and carry out near-surface seismic surveys, working with specialist partners where deep reflection is required. See geophysical surveys in Kenya and geophysics in site investigation.
Frequently asked questions
How is reflection different from refraction?
Reflection records waves bouncing back from boundaries and images layers in detail, including where velocity decreases. Refraction uses waves travelling along boundaries and mainly gives velocities and depths of faster layers.
Is seismic reflection only for oil and gas?
No. High-resolution shallow reflection is used for engineering, groundwater, mining and geological mapping, although it is more complex and costly than refraction.
Why does reflection need so much processing?
Raw records contain noise and other wave types. Processing such as filtering, stacking and migration turns them into a clear image of the subsurface.
📡 Request a geophysical survey quote
The cost of a geophysical survey depends mainly on the area or length of survey lines, the methods and depth of investigation needed, and site access. Tell us about your project and we will propose a survey design and quotation.
We reply with a proposed survey design and quotation. Prices are not listed online because every site and target is different.
Plan your geophysical survey
Tell us your site, target and depth of interest. We will recommend the right methods and send a survey design and quotation.