Get a Quote
← All articles

Submersible Borehole Pumps: Components, Working Principles and Applications

How submersible borehole pumps work: multistage pump ends, motors, intake, non-return valves, cooling, materials and their applications in domestic, farm and industrial supply.

By Quantum Geoconsultants pump installation teamUpdated 19 November 20262 min read
TopsoilLava flowOlder lavas & tuffsStatic water level (pump off) Pumping water level ◀ Submersible pump & motor ◀ Screen below the pump Pump sized from test pumping

⚙️ Borehole Pumps & Solar: a technical article by the Quantum Geoconsultants pump installation team.

The submersible borehole pump is the most common way to lift groundwater. It works deep inside the borehole, pushing water up rather than sucking it. This article explains its components, how it works and where it is used.

Why submersible?

Surface pumps can only suck water from a few metres depth. Submersible pumps sit below the water level and push water up, so they can lift from tens or hundreds of metres.

Main components

Pump end

A series of impellers and diffusers (stages) stacked in a slim housing. Each spinning impeller adds energy to the water; diffusers convert that energy into pressure and guide water to the next stage. More stages give more head.

Motor

A sealed electric motor, filled with water or oil, mounted below the pump end. Motors may be single-phase or three-phase, or DC or permanent-magnet types in solar systems.

Intake

Between motor and pump, protected by a screen. Water entering here flows past the motor, cooling it.

Non-return valve

At the pump outlet, it stops water flowing back down when the pump stops, protecting against water hammer and reverse rotation.

Cable

A waterproof submersible cable connected to the motor lead by a sealed splice.

How it works

  1. The motor turns the shaft and impellers.
  2. Water enters the intake and is accelerated by the first impeller.
  3. Each stage increases pressure.
  4. Pressurised water exits through the non-return valve into the rising main.

Performance

A pump’s performance curve shows head against flow. As head increases, flow decreases. Efficiency peaks at the best efficiency point. Selecting pumps near this point saves energy. See selecting a submersible pump.

Cooling

Motors depend on water flowing past them at a minimum velocity. If the pump sits in a wide casing or below the screens, a cooling shroud may be needed. See pump submergence.

Materials

Applications

Protecting the pump

Dry-run protection, voltage and phase monitoring, correct cable sizing and proper installation are essential for long life. See control panels and protection.

How Quantum Geoconsultants can help

We supply, install and maintain submersible pumps for all applications. See borehole pump installation and our pump installation guide.

Frequently asked questions

Why are borehole pumps multistage?

Each impeller stage adds pressure. Stacking stages lets a slim pump lift water from great depths.

Where is the motor in a submersible pump?

Below the pump end. Water is drawn in through an intake between the motor and pump, cooling the motor as it flows past.

Can a submersible pump run dry?

It should not. Dry running quickly overheats and damages the pump and motor, which is why dry-run protection is important.

⚙️ Borehole pump size calculator

Enter your borehole's numbers from the test pumping report (or your best estimate) to see the total head, the flow and roughly how big a submersible pump or solar array you need.

0total head (m)
0pump flow (m³/hour)
0solar array (watts)

Rough planning figures only. Total head = pumping water level + tank height + an allowance for pipe friction. The final pump is chosen from the manufacturer's pump curves, your test pumping yield and your water quality.

Get a borehole pump installation quote

Send us your test pumping report, borehole depth and where the tank will sit. We will size the right submersible or solar pump and send a quotation for supply, installation and commissioning.

💬 WhatsApp