The rising main, cable and accessories connect the pump to the surface. Choosing and installing them correctly prevents many common failures. This article covers the rising main, pump cable and other borehole accessories.
Rising main options
- uPVC threaded pipe: corrosion-free and economical for moderate depths and loads.
- HDPE pipe: flexible, continuous lengths for smaller pumps.
- Galvanised steel: strong but prone to corrosion in aggressive water.
- Stainless steel: strong and durable, higher cost.
- Flexible lay-flat hose: lightweight, quick to install and remove, rated for high pressures.
The pipe must handle the pump’s maximum pressure, the weight of pump, pipe and water, and the water’s chemistry.
Diameter
Larger diameters reduce friction losses but cost more and must fit in the casing with the cable. Friction calculations guide the choice. See calculating pumping head.
Submersible cable
- Use proper submersible cable rated for immersion.
- Size conductors to limit voltage drop over the full length at full load current.
- Make splices with approved waterproof kits.
- Avoid damaging insulation against casing edges.
Safety rope
A stainless steel wire or suitable non-rotting rope attached to the pump supports it if the rising main fails and makes recovery safer.
Cable ties and clamps
Cable and rope are fixed to the rising main at regular intervals so they do not tangle or rub.
Torque arrestor
When a pump starts, it twists the rising main. A torque arrestor centralises the pump in the casing and reduces twisting and wear, especially for larger pumps.
Dip tube
A small pipe alongside the rising main, open at the bottom, lets water levels be measured safely. Essential for monitoring. See water levels and submergence.
Non-return valves
A non-return valve at the pump outlet, and often another at the surface, prevents backflow and water hammer.
Wellhead fittings
- Sealed wellhead plate or cap
- Gate valve and non-return valve
- Pressure gauge
- Flow meter
- Sampling tap
- Air release valve where needed
Installation tips
- Use proper lifting equipment and clamps.
- Apply correct thread sealant and torque.
- Keep components clean to avoid contaminating the borehole.
- Disinfect the borehole after installation for drinking water supplies.
How Quantum Geoconsultants can help
We specify and install complete pumping assemblies. See pump installation and installation procedures.
Frequently asked questions
What pipe is best for a rising main?
uPVC, HDPE, galvanised steel, stainless steel and flexible lay-flat hose are all used. The choice depends on depth, pump weight, water quality and pressure.
How is pump cable sized?
By motor current and cable length, so voltage drop stays within acceptable limits. Long cables often need larger conductors.
Why install a dip tube?
It allows water levels to be measured safely without the probe snagging on the cable or rising main.
⚙️ Borehole pump size calculator
Enter your borehole's numbers from the test pumping report (or your best estimate) to see the total head, the flow and roughly how big a submersible pump or solar array you need.
Rough planning figures only. Total head = pumping water level + tank height + an allowance for pipe friction. The final pump is chosen from the manufacturer's pump curves, your test pumping yield and your water quality.
Send these numbers on WhatsAppGet a borehole pump installation quote
Send us your test pumping report, borehole depth and where the tank will sit. We will size the right submersible or solar pump and send a quotation for supply, installation and commissioning.