The seismic refraction survey is a classic method for mapping soil and rock layers, especially depth to bedrock and the quality of rock for excavation. It is widely used for roads, quarries, dams, pipelines and building foundations.
The principle
A seismic source, usually a sledgehammer on a steel plate, generates waves that travel into the ground. Where a faster layer lies below a slower one, part of the energy is refracted along the boundary and returns to the surface. Geophones laid out in a line record the arrival times. Beyond a certain distance, the refracted wave arrives before the direct wave, revealing the velocity and depth of the deeper layer.
Field procedure
- Lay out 24 or 48 geophones at regular spacing (often 2 to 5 m).
- Connect them to a seismograph.
- Fire shots at several positions: both ends, beyond the ends (offset shots) and at intervals along the line.
- Stack several hammer blows at each position to improve signal.
- Survey geophone positions and elevations.
Interpretation
First arrival times are picked from each record and plotted against distance (time-distance or travel-time plots). Straight-line segments correspond to layers, with slopes giving velocities. Methods include:
- Intercept-time and crossover methods for simple layered ground.
- Delay-time and generalised reciprocal methods for irregular boundaries.
- Tomographic inversion, producing a smooth velocity section that handles complex geology.
Typical P-wave velocities
| Material | Approximate velocity (m/s) |
|---|---|
| Dry topsoil and loose sand | 200 to 800 |
| Saturated soils | about 1,500 and above |
| Weathered rock | 1,000 to 2,500 |
| Moderately fractured rock | 2,500 to 4,000 |
| Fresh igneous and metamorphic rock | 4,000 to 6,000 |
Note that the water table can appear as a refractor at about 1,500 m/s, which must not be mistaken for rock.
Applications
- Depth to bedrock for foundations, piles and excavations. See determining depth to bedrock.
- Rippability: velocity charts published by equipment manufacturers relate velocity to rippability for different machines.
- Quarry and borrow pit assessment.
- Dam and bridge sites: rock quality and weathering profiles.
- Landslide studies: depth of weak material.
Limitations
- Velocity inversion: a slower layer beneath a faster one is not detected and causes depth errors.
- Hidden layers: thin layers may not produce first arrivals.
- Noise from traffic and machinery.
- Source energy limits depth for hammer sources, usually to some tens of metres.
Combining refraction with MASW and boreholes gives a more reliable ground model.
How Quantum Geoconsultants can help
We carry out seismic refraction surveys for rock depth and rippability. See seismic refraction surveys in Kenya, geophysics for construction and rock core logging.
Frequently asked questions
What does a seismic refraction survey measure?
The travel times of seismic waves refracted along layer boundaries, from which layer velocities and depths are calculated.
What is rippability?
It is how easily rock can be excavated by a ripper on a bulldozer. Seismic velocity is a common indicator, with higher velocities usually needing heavier equipment or blasting.
When does seismic refraction not work well?
When a slower layer lies beneath a faster one (velocity inversion), or when layers are too thin to detect.
📡 Request a geophysical survey quote
The cost of a geophysical survey depends mainly on the area or length of survey lines, the methods and depth of investigation needed, and site access. Tell us about your project and we will propose a survey design and quotation.
We reply with a proposed survey design and quotation. Prices are not listed online because every site and target is different.
Plan your geophysical survey
Tell us your site, target and depth of interest. We will recommend the right methods and send a survey design and quotation.