When a borehole stops delivering water, the cause may be in the pump, the electrics, the pipework or the borehole itself. This guide covers common borehole pump problems and how to troubleshoot them systematically.
Start with safety and information
- Isolate power before touching electrical parts.
- Check the control panel for fault lights or messages.
- Compare current readings with commissioning records.
- Measure water level through the dip tube.
Problem: Pump does not start
- No power: check supply, breakers, fuses.
- Protection tripped: dry-run, overload or voltage relay.
- Tank full or float switch faulty.
- Faulty contactor or controller.
- Damaged cable or motor: test insulation and continuity.
Problem: Pump runs but no water
- Water level below pump: borehole dry or over-pumped.
- Broken or disconnected rising main.
- Closed valve or blocked non-return valve.
- Pump intake blocked or pump shaft broken.
Problem: Low flow
- Falling water level increasing head
- Worn impellers from sand
- Leaking joints in the rising main
- Clogged screens or intake
- Wrong rotation on three-phase pumps
- Low voltage or, for solar, dirty panels or poor sunshine
Compare flow and pressure with the pump curve. See pump testing.
Problem: Frequent tripping
- Unstable or low supply voltage
- Dry running as levels fall
- Pump partly jammed by sand or scale
- Undersized cable causing voltage drop
- Incorrect protection settings
Problem: Frequent starting and stopping
- Tank too small or float switch band too narrow
- Failed pressure tank in pressure systems
- Dry-run protection repeatedly tripping in a low-yield borehole
See tank sizing.
Problem: Sand or dirty water
- Inadequate borehole development or gravel pack
- Damaged screen or casing
- Pumping above safe yield
- Pump set too close to the bottom
A camera inspection often reveals the cause.
Problem: Low pressure at taps
See causes of low water pressure.
When to pull the pump
If tests point to the pump or cable, the pump must be pulled for inspection. Record findings: wear, scale, corrosion or sand, as these indicate the root cause.
Preventing problems
Correct sizing, protection, installation and regular maintenance prevent most issues. See pump maintenance.
How Quantum Geoconsultants can help
We diagnose and repair borehole pumping systems. See pump installation and repair and borehole flushing.
Frequently asked questions
Why does my borehole pump keep tripping?
Common causes are low or unstable voltage, dry running, a jammed or worn pump, wrong settings, or damaged cable insulation.
Why has my borehole output dropped?
Possible causes include falling water levels, a clogged screen or pump intake, worn impellers, leaks in the rising main or blocked pipes.
Why is there sand in my water?
Poor borehole construction or development, damaged screens, or pumping above the safe yield can draw sand into the borehole.
⚙️ Borehole pump size calculator
Enter your borehole's numbers from the test pumping report (or your best estimate) to see the total head, the flow and roughly how big a submersible pump or solar array you need.
Rough planning figures only. Total head = pumping water level + tank height + an allowance for pipe friction. The final pump is chosen from the manufacturer's pump curves, your test pumping yield and your water quality.
Send these numbers on WhatsAppGet a borehole pump installation quote
Send us your test pumping report, borehole depth and where the tank will sit. We will size the right submersible or solar pump and send a quotation for supply, installation and commissioning.