Choosing a borehole pump is not just about horsepower. The right submersible pump delivers the flow you need at the head your system requires, within what the borehole can safely supply, at good efficiency. This article explains how to choose.
1. Start with the borehole data
- Safe yield: the maximum sustainable pumping rate from test pumping.
- Dynamic water level at that rate.
- Casing internal diameter.
- Borehole depth and screen positions.
- Water quality: corrosiveness, sand, iron.
See borehole yield and pump selection.
2. Define the duty point
The duty point is the flow you need (m³/h) and the total dynamic head (m) at that flow. Flow should not exceed the safe yield. See TDH and flow rate.
3. Read pump curves
Each pump has a curve showing head against flow. Choose a model whose curve passes through or just above your duty point, ideally close to its best efficiency point. Pumps operating far from this point use more energy and wear faster.
4. Check physical fit
Submersible pumps come in standard diameters, commonly 3, 4 and 6 inches. The casing must allow clearance for the pump, cable and any cooling shroud. A borehole too narrow limits pump choice, which is why borehole design should consider future pumping needs.
5. Match the power supply
- Single-phase motors for smaller pumps on domestic supply.
- Three-phase motors for larger pumps; more efficient and robust.
- Solar: DC pumps or AC pumps with solar inverters. See solar pumping.
Cable size must keep voltage drop within limits over the full cable length.
6. Materials and water quality
- Stainless steel pumps resist corrosion and are widely used.
- Highly saline or aggressive water may need higher-grade stainless steel.
- Sandy boreholes need sand-tolerant designs and proper borehole development.
7. Motor cooling and setting depth
Submersible motors are cooled by water flowing past them. If the pump must be set below the screens, a cooling shroud directs flow over the motor. See water levels and pump submergence.
8. Think about the whole system
Storage tanks, pressure needs and demand patterns affect the best choice. A smaller pump running longer into a tank is often better than a large pump running briefly. See tank sizing.
Common selection errors
- Oversizing beyond safe yield, causing dry running
- Ignoring friction losses in long pipelines
- Choosing on price instead of efficiency and durability
- No allowance for falling water levels in the dry season
How Quantum Geoconsultants can help
We select pumps using test pumping data and full hydraulic calculations. See borehole pump installation and our complete pump guide.
Frequently asked questions
What size pump do I need?
It depends on the flow you need, the total head and the borehole's safe yield. A pump curve shows whether a model meets that duty point.
Does a 4-inch pump fit a 4-inch borehole?
Usually not. 4-inch pumps typically need casing with an internal diameter somewhat larger than 4 inches to allow for the cable and clearance.
Why does water quality affect pump choice?
Corrosive or sandy water can damage standard pumps. Stainless steel pumps and suitable materials last longer in aggressive water.
⚙️ Borehole pump size calculator
Enter your borehole's numbers from the test pumping report (or your best estimate) to see the total head, the flow and roughly how big a submersible pump or solar array you need.
Rough planning figures only. Total head = pumping water level + tank height + an allowance for pipe friction. The final pump is chosen from the manufacturer's pump curves, your test pumping yield and your water quality.
Send these numbers on WhatsAppGet a borehole pump installation quote
Send us your test pumping report, borehole depth and where the tank will sit. We will size the right submersible or solar pump and send a quotation for supply, installation and commissioning.