A survey is only useful if it is reliable. Understanding accuracy, precision and quality control helps clients specify what they need and judge what they receive. This article explains the key ideas in engineering surveying.
Accuracy and precision
- Accuracy: how close a result is to the true value.
- Precision: how consistent repeated measurements are.
A survey can be precise but inaccurate, for example if every point is shifted because of a wrong control coordinate. Good surveys are both.
Types of error
- Gross errors (blunders): wrong target height, misread staff, wrong point code. Caught by checks.
- Systematic errors: consistent bias, such as an uncalibrated instrument, wrong coordinate transformation or prism constant. Removed by calibration and correct procedures.
- Random errors: small unavoidable variations. Reduced by repeated measurements and adjustment.
Sources of error
- Instrument: calibration, collimation, centring.
- Environment: heat shimmer, refraction, wind, satellite geometry, multipath.
- Human: setup, reading and recording.
- Processing: wrong datum, projection or geoid model.
Quality control methods
Redundancy
Measuring more than the minimum needed allows errors to be detected. Examples: observing control from multiple points, double levelling, repeating GNSS occupations.
Closed traverses and level loops
Traverses and levelling are closed back on known points. The misclosure is compared with allowable limits, then adjusted. Levelling tolerances are commonly expressed as a few millimetres multiplied by the square root of the distance in kilometres.
Least squares adjustment
Distributes random errors statistically across a network and gives accuracy estimates for every point.
Check points
Independent points not used in processing, especially for drone and LiDAR surveys, verify final accuracy. Results are reported as residuals or root mean square error.
Instrument calibration
Regular calibration and field checks of total stations, levels and GNSS receivers.
Field and office checks
Reviewing data for spikes, missing features and inconsistent levels before delivery.
Specifying accuracy
Specifications should state the required horizontal and vertical accuracy for control, detail and models, appropriate to the purpose. Over-specifying increases cost; under-specifying risks design errors.
Reporting
A good survey report states the coordinate system and datum, control used, methods, instruments, closure results, check point results and any limitations. This lets designers trust and correctly use the data.
Common quality problems
- Wrong datum or coordinate system
- Uncalibrated instruments
- No independent checks
- Drone models used without ground control or check points
How Quantum Geoconsultants can help
Our surveys include documented control, checks and accuracy reporting. See control points and benchmarks, surveying methods and topographic surveys.
Frequently asked questions
What is the difference between accuracy and precision?
Accuracy is how close a measurement is to the true value. Precision is how close repeated measurements are to each other.
What is a misclosure?
The difference between where a traverse or levelling loop ends and where it should end. It indicates the size of accumulated errors.
How can I check a survey's accuracy?
Ask for check point comparisons, closure results, control details and a statement of methods and expected accuracy.
📐 Request a topographic survey quote
The cost of a topographic survey depends mainly on the size of the site, the level of detail needed, the ground cover and whether a drone can be used. Tell us about your site and we will recommend a method and send a quotation.
We reply with the recommended method, deliverables and a quotation. Prices are not listed online because every site is different.
Get a topographic survey quote
Send us your site location, its approximate size and what the survey is for. We will recommend ground or drone methods and send a quotation, including mobilisation from our Nairobi base.