Drill cuttings give a rough picture of the ground, but they are mixed and delayed as they travel up the hole. Borehole geophysical logging lowers instruments (sondes) down the borehole to make continuous measurements, giving a much clearer picture of layers, aquifers and fractures.
How logging works
A logging truck or portable winch lowers a sonde on a cable. Measurements are recorded continuously against depth, producing logs that can be compared side by side. Several sondes may be run in the same hole.
Common logs
Natural gamma
Measures natural radioactivity. Clays and shales usually read higher than clean sands, sandstones and limestones. It works in open or plastic-cased holes, making it the most widely used log for lithology.
Resistivity logs
Measure the electrical resistivity of the formation (normal, lateral or focused tools). Combined with gamma, they distinguish clay, fresh-water sands and saline zones. They require an open, fluid-filled hole.
Spontaneous potential (SP)
Measures natural voltages between borehole fluid and formation, helping identify permeable beds and water salinity contrasts.
Caliper
Measures borehole diameter, showing washouts, caving zones and fractures, and correcting other logs.
Fluid temperature and conductivity
Changes along the hole reveal where water enters and its quality, useful for identifying productive and saline zones.
Flowmeter
Measures vertical flow in the borehole, under natural or pumped conditions, showing which zones contribute water.
Sonic
Measures acoustic velocity, related to rock strength and porosity.
Optical and acoustic televiewers
Produce oriented images of the borehole wall, showing fractures, bedding and their orientation, valuable in rock engineering and mineral exploration.
Camera inspection
Video cameras inspect casing and screens in completed boreholes. See our borehole camera inspection.
Applications
- Water boreholes: identifying aquifers and clays to place screens and casing correctly, and saline zones to seal off.
- Geotechnical investigations: rock fracturing, strength and layer boundaries.
- Mineral exploration: lithology, structure orientation and density.
- Geothermal and petroleum: temperature, porosity and fluid properties.
- Calibrating surface geophysics: linking resistivity and seismic surveys to real layers.
Practical considerations
- Logging must be done before casing for resistivity and SP logs.
- Unstable holes may collapse, so timing and hole condition matter.
- Logs should be depth-referenced accurately and compared with drilling records.
Why it pays off
Placing screens precisely opposite productive zones, and casing off clay or saline layers, can significantly improve yield and water quality. The cost of logging is small compared with the cost of a poorly designed borehole.
How Quantum Geoconsultants can help
We use logging and camera inspection to design and assess boreholes. See borehole drilling, borehole drilling procedures and integrating geophysics and drilling.
Frequently asked questions
Why log a borehole geophysically?
Logs give continuous, objective measurements down the hole that identify layers, aquifers, fractures and water quality zones more precisely than cuttings alone.
Which log identifies clay?
The natural gamma log, because clay minerals usually contain more radioactive potassium, thorium and uranium than clean sands.
When should water boreholes be logged?
After drilling and before casing is installed, so the logs can guide where to place screens.
📡 Request a geophysical survey quote
The cost of a geophysical survey depends mainly on the area or length of survey lines, the methods and depth of investigation needed, and site access. Tell us about your project and we will propose a survey design and quotation.
We reply with a proposed survey design and quotation. Prices are not listed online because every site and target is different.
Plan your geophysical survey
Tell us your site, target and depth of interest. We will recommend the right methods and send a survey design and quotation.