A water tower needs a reliable way to fill it. Depending on the source, this may be a borehole pump, a booster pump from a ground tank or mains pressure. This article covers selecting and installing pumps and pipelines for water tower filling.
Filling sources
- Borehole: submersible pump directly to the tower. See borehole integration.
- Ground tank or sump: surface centrifugal pump lifting to the tower.
- Mains supply: may fill the tower directly if pressure is sufficient, often at night.
- Rainwater tanks: transfer pump to the elevated tank.
Sizing the pump
- Calculate required flow to fill the tank within available hours.
- Calculate total head: lift to tank inlet plus friction plus any suction lift. See calculating head.
- Select a pump whose curve meets this duty near its best efficiency point.
- For surface pumps, check suction conditions to avoid cavitation (keep suction short and flooded where possible).
Pipeline design
- Size pipes to keep friction losses and velocities reasonable.
- Use pressure-rated pipe (uPVC, HDPE or steel).
- Support the riser up the tower securely, with brackets at intervals.
- Protect exposed plastic pipes from UV.
- Bury pipes where possible to protect them.
Valves and fittings
- Non-return valve after the pump
- Isolation valves for maintenance
- Air release valve at high points
- Flow meter to record supply
- Pressure gauge at the pump outlet
See plumbing, valves and fittings.
Controls
- Float switch or level sensor in the tower tank to stop and start the pump.
- Low-level protection in the source tank or borehole.
- Overload and voltage protection.
See control panels and protection.
Installation tips
- Mount surface pumps on a level, solid base in a ventilated, protected housing.
- Avoid unsupported pipe weight on pump connections.
- Prime surface pumps before starting.
- Test the system with the tank filling and confirm automatic shut-off.
Energy efficiency
Pumping at a moderate rate over longer hours often uses less energy than fast pumping, due to lower friction. Solar can power filling during the day. See solar pumping for elevated tanks.
How Quantum Geoconsultants can help
We design and install pumping and pipelines for water towers. See pump installation and water tower construction.
Frequently asked questions
What pump fills a water tower from a ground tank?
A surface centrifugal or booster pump sized for the flow and the head to the tank inlet, with suction conditions checked.
Should the filling pipe enter at the top of the tank?
Usually yes, with an air gap or suitable arrangement to prevent backflow and allow the tank to fill evenly.
How is the pump stopped when the tank is full?
With a float switch or level sensor connected to the pump control, plus an overflow for safety.
🏗️ Tank and water tower calculator
Work out the tank size you need, the water pressure your tower will give at the taps, and how heavy the full tank will be. That load is what the tower foundation must carry.
Each metre of height gives about 0.1 bar of pressure. Rough planning figures only: the tower and foundation must be designed by an engineer for the tank load, wind and your ground conditions.
Send these numbers on WhatsAppGet a water tower quote
Send us your site location, tank size and the height you need. We will design the tower and foundation and send a quotation, including mobilisation from our Nairobi base.