Water can leave a borehole clean and become contaminated in storage. Good sanitary protection and maintenance of elevated tanks keep stored water safe to drink.
How stored water becomes contaminated
- Open or poorly fitting hatches and lids
- Unscreened vents and overflows letting in insects, birds and rodents
- Dust and leaves entering
- Sediment and biofilm build-up
- Unsuitable tank materials or linings
- Backflow from contaminated pipes
Design for sanitary protection
- Fully covered tanks with tight, lockable hatches
- Fine mesh screens on vents and overflows
- Outlet above the tank floor and a drain at the lowest point
- Materials approved for drinking water
- Backflow prevention on inlets
- Access for inspection and cleaning
See plumbing, valves and fittings.
Temperature
Warm water encourages bacterial growth. Light-coloured or insulated tanks, shading and avoiding long storage times help keep water cooler.
Water turnover
Oversized tanks with low use can hold water for long periods, reducing quality. Size tanks sensibly and ensure regular turnover. See capacity calculations.
Cleaning
- Isolate and drain the tank.
- Remove sediment and scrub surfaces.
- Inspect the interior for damage.
- Rinse thoroughly.
Commonly every six to twelve months, more often if needed.
Disinfection
After construction, repairs or cleaning, tanks are disinfected with chlorine solution at a specified concentration and contact time, following recognised procedures for water storage facilities, then flushed and tested before return to service. Workers entering tanks must follow confined-space safety procedures.
Treatment and residual chlorine
Where water is chlorinated, maintaining a small residual chlorine level in storage helps protect against contamination. Where treatment is used for borehole water, it should be designed for the specific water quality. See groundwater quality assessment.
Testing
- Bacteriological testing for E. coli and coliforms
- Turbidity and residual chlorine checks
- Periodic chemical testing
Public and institutional supplies need regular testing programmes.
How Quantum Geoconsultants can help
We design hygienic storage systems and advise on cleaning and testing. See water tower construction and inspection and maintenance.
Frequently asked questions
Can water become contaminated in a storage tank?
Yes. Dust, insects, birds, rodents, sediment and biofilm can contaminate stored water if tanks are poorly sealed or not cleaned.
How is a tank disinfected?
After cleaning, it is treated with a chlorine solution for a contact period according to recognised procedures, then flushed and tested before use.
Should stored water be tested?
Yes. Regular bacteriological testing, especially for public and institutional supplies, confirms the water remains safe.
🏗️ Tank and water tower calculator
Work out the tank size you need, the water pressure your tower will give at the taps, and how heavy the full tank will be. That load is what the tower foundation must carry.
Each metre of height gives about 0.1 bar of pressure. Rough planning figures only: the tower and foundation must be designed by an engineer for the tank load, wind and your ground conditions.
Send these numbers on WhatsAppGet a water tower quote
Send us your site location, tank size and the height you need. We will design the tower and foundation and send a quotation, including mobilisation from our Nairobi base.