LiDAR (Light Detection and Ranging) measures the world with laser pulses, capturing millions of precise 3D points. It has become a key tool in topographic mapping, especially where vegetation hides the ground. This article explains how a LiDAR survey works and when to use it.
How LiDAR works
A scanner emits rapid laser pulses and measures the time for each reflection to return. Combined with precise position and orientation from GNSS and an inertial measurement unit (IMU), each return becomes a 3D point. A single pulse can produce several returns, from leaves, branches and finally the ground.
Platforms
- Airborne LiDAR: aircraft or helicopters covering very large areas.
- Drone LiDAR: high-density data over sites and corridors.
- Mobile LiDAR: vehicle-mounted scanning of roads and urban areas.
- Terrestrial laser scanning: tripod-based scanning of buildings, structures, quarries and facades.
Advantages
- Ground under vegetation: multiple returns allow bare-earth models in bushy or forested areas.
- Speed and density: very large numbers of points quickly.
- Works in low light: an active sensor, independent of sunlight.
- Complex structures: power lines, bridges and building facades.
Processing
- Combine scanner data with GNSS/IMU trajectory.
- Calibrate and adjust strips to remove offsets.
- Classify points: ground, vegetation, buildings, wires.
- Create DTMs, DSMs, contours and features. See DTMs and DEMs.
- Check accuracy against ground control.
Accuracy
Vertical accuracies of a few centimetres are achievable with drone and terrestrial systems on hard surfaces. Accuracy in vegetation depends on how many pulses reach the ground. Specifications should state point density and accuracy requirements.
Applications
- Road, railway and pipeline corridors through vegetated terrain
- Power line surveys and vegetation clearance
- Flood modelling, where accurate ground levels matter
- Forestry and environmental studies
- Mining, quarry and stockpile surveys
- Building and heritage documentation
LiDAR or photogrammetry?
| Situation | Better choice |
|---|---|
| Open, bare sites | Photogrammetry (cost-effective, good imagery) |
| Bush, forest, tall grass | LiDAR |
| Power lines and thin structures | LiDAR |
| Need for detailed colour orthophoto | Photogrammetry, or LiDAR with a camera |
See drone photogrammetry.
Limitations
- Higher equipment and processing costs.
- Water surfaces absorb or scatter pulses (special bathymetric LiDAR exists for shallow clear water).
- Very dense canopy still blocks the ground.
How Quantum Geoconsultants can help
We advise on the best mapping technology for each site and integrate LiDAR, drone and ground survey data. See drone surveys and topographic surveys.
Frequently asked questions
What is LiDAR?
Light Detection and Ranging uses laser pulses to measure distances very rapidly, producing dense 3D point clouds of the ground and objects.
Can LiDAR see through trees?
Not through solid canopy, but laser pulses pass through gaps in foliage and some reach the ground, allowing bare-earth models in vegetated areas.
Is LiDAR better than drone photogrammetry?
It is better in vegetated areas and for complex structures, while photogrammetry is often cheaper for open sites and gives better colour imagery.
📐 Request a topographic survey quote
The cost of a topographic survey depends mainly on the size of the site, the level of detail needed, the ground cover and whether a drone can be used. Tell us about your site and we will recommend a method and send a quotation.
We reply with the recommended method, deliverables and a quotation. Prices are not listed online because every site is different.
Get a topographic survey quote
Send us your site location, its approximate size and what the survey is for. We will recommend ground or drone methods and send a quotation, including mobilisation from our Nairobi base.