Get a Quote
← All articles

Water Tower Plumbing, Valves, Fittings and Pipeline Connections

The plumbing every water tower needs: inlet, outlet, overflow, drain, vent, float valves, isolation valves, non-return valves, level indicators and supports, with good practice tips.

By Quantum Geoconsultants water tower teamUpdated 19 November 20262 min read
pressure QGL ◀ Nairobi TopsoilRed soil over weathered rockFoundation pads ▲ Mobilised from Nairobi

🗼 Water Towers & Storage: a technical article by the Quantum Geoconsultants water tower team.

The plumbing on a water tower controls how water enters, leaves and stays clean. Getting it right prevents overflows, sediment problems, contamination and pipe failures. This article explains the essential water tower plumbing.

Essential connections

Inlet

Usually near the top of the tank, with a float valve or level-controlled pump. An air gap or suitable arrangement prevents backflow into the supply.

Outlet

Slightly above the tank floor so settled sediment is not drawn into the supply. An isolation valve allows maintenance.

Overflow

Near the top, sized to carry the maximum inflow, discharging visibly and safely away from foundations. A mesh or flap prevents insects and animals entering.

Drain (washout)

At the lowest point of the tank, with a valve, for emptying and cleaning.

Vent

Allows air movement as the tank fills and empties. Screened to keep out insects and dust.

Valves

Level indication and control

Pipe supports and protection

Materials

Use materials suitable for drinking water: food-grade plastics, galvanised or stainless steel, and approved fittings and sealants. Avoid mixing incompatible metals that cause corrosion.

Common mistakes

Water quality

Good plumbing design supports clean water: sealed connections, screened openings and access for cleaning. See water quality and sanitary protection.

How Quantum Geoconsultants can help

We supply and install complete tower plumbing. See water tower construction and installation procedures.

Frequently asked questions

Why should the outlet be above the tank floor?

So sediment that settles on the floor is not drawn into the supply. A drain at the lowest point removes it during cleaning.

Does a water tank need an overflow?

Yes. An overflow prevents damage if the inlet control fails and should discharge safely away from foundations.

Why does a tank need a vent?

Venting lets air in and out as the tank fills and empties, preventing damage from pressure or vacuum. Vents should be screened against insects.

🏗️ Tank and water tower calculator

Work out the tank size you need, the water pressure your tower will give at the taps, and how heavy the full tank will be. That load is what the tower foundation must carry.

0tank size (litres)
0pressure at ground taps (bar)
0weight of water when full (tonnes)

Each metre of height gives about 0.1 bar of pressure. Rough planning figures only: the tower and foundation must be designed by an engineer for the tank load, wind and your ground conditions.

Get a water tower quote

Send us your site location, tank size and the height you need. We will design the tower and foundation and send a quotation, including mobilisation from our Nairobi base.

💬 WhatsApp