Get a Quote
← All articles

Testing, Commissioning and Performance Evaluation of Water Tower Systems

How water tower systems are tested and commissioned: structural checks, watertightness tests, plumbing and control tests, disinfection, pressure checks at outlets and handover records.

By Quantum Geoconsultants water tower teamUpdated 19 November 20262 min read
pressure QGL ◀ Nairobi TopsoilRed soil over weathered rockFoundation pads ▲ Mobilised from Nairobi

🗼 Water Towers & Storage: a technical article by the Quantum Geoconsultants water tower team.

Before a water tower goes into service, it must be proven safe, watertight and working as designed. Testing and commissioning confirm this and set a baseline for future maintenance.

1. Pre-commissioning checks

2. Watertightness test

  1. Fill the tank gradually, checking the structure as load increases.
  2. Once full, record the water level.
  3. Observe over a period, often a few days for larger tanks, checking for drops in level, damp patches and drips.
  4. Repair leaks and retest if needed.

Concrete tanks may show initial absorption, so tests follow the specification’s procedure.

3. Structural checks with a full tank

See foundation design.

4. Plumbing and control tests

5. Pump system tests

Where a pump fills the tower, confirm flow, head and automatic start and stop. See pump testing and commissioning.

6. Pressure and flow at outlets

Measure pressure and flow at critical outlets, especially the highest and furthest, to confirm design performance. See pressure and hydraulic head.

7. Cleaning and disinfection

The tank and pipework are cleaned, disinfected, flushed and tested for bacteria before the water is used for drinking. See water quality and sanitary protection.

8. Handover documentation

9. Performance evaluation over time

After handover, periodic checks of verticality, leaks, pressures and water quality compare performance with commissioning results. See inspection and maintenance.

How Quantum Geoconsultants can help

We test and commission water towers and integrated pumping systems. See water tower construction and our water tower guide.

Frequently asked questions

How is a new tank tested for leaks?

It is filled and observed over a period, with the water level and any damp patches or drips monitored.

Should the tower be checked when full?

Yes. Verticality and foundations should be checked with the tank full, since this is the main load case.

What records should be handed over?

Drawings, design calculations or certificates, test results, disinfection and water test records, and maintenance guidance.

🏗️ Tank and water tower calculator

Work out the tank size you need, the water pressure your tower will give at the taps, and how heavy the full tank will be. That load is what the tower foundation must carry.

0tank size (litres)
0pressure at ground taps (bar)
0weight of water when full (tonnes)

Each metre of height gives about 0.1 bar of pressure. Rough planning figures only: the tower and foundation must be designed by an engineer for the tank load, wind and your ground conditions.

Get a water tower quote

Send us your site location, tank size and the height you need. We will design the tower and foundation and send a quotation, including mobilisation from our Nairobi base.

💬 WhatsApp