Reverse circulation (RC) drilling is the workhorse of mineral exploration. It drills fast and produces chip samples for every metre, making it ideal for testing targets and defining resources economically. This article explains how it works and how to get good samples.
How RC drilling works
RC uses dual-walled drill rods. Compressed air travels down the space between the outer and inner tubes to a percussion hammer, which breaks the rock. The air then returns up the inner tube, carrying cuttings to the surface. Because cuttings travel inside the rods rather than up the hole wall, contamination from higher in the hole is reduced.
The sampling system
- Cuttings exit the rods into a cyclone, which slows the air and separates chips.
- Chips pass through a splitter (cone, riffle or rotary) that divides the sample.
- A representative split (often a few kilograms) is bagged for assay; the remainder is kept for logging and reference.
- A small portion is sieved and placed in chip trays for geological logging.
Advantages
- Fast penetration and low cost per metre
- Continuous 1-metre samples
- Good recovery in dry, competent ground
- Rapid turnaround for decision-making
Limitations
- No core: limited structural and textural information.
- Groundwater: wet samples can lose fines and cause contamination.
- Depth: limited by air pressure and water.
- Broken ground: may cause sample loss and hole problems.
Sample quality control
- Weigh samples to monitor recovery.
- Record wet or dry condition of each sample.
- Clean the cyclone and splitter regularly, especially after wet or high-grade intervals.
- Maintain good air pressure and hammer condition.
- Take field duplicates and insert standards and blanks. See QA/QC.
Logging RC chips
Geologists log lithology, alteration, veining, sulphides and weathering from chip trays. Chips are less informative than core, so logging codes are kept practical and consistent. See geological logging.
RC with diamond tails
For deep targets, RC drills the upper part quickly (pre-collar), then diamond drilling continues through the target zone. This combines speed with core quality. See RC and diamond drilling compared.
RC in resource drilling
Resource definition often relies on RC drilling on regular grids, with diamond holes for geology, density and verification. Twinned holes (RC beside diamond) test whether RC samples are biased.
RC for water boreholes
Reverse circulation principles are also used in large-diameter water well drilling. See borehole drilling methods.
How Quantum Geoconsultants can help
We plan and supervise RC programmes, manage sampling and log chips. See mineral exploration in Kenya.
Frequently asked questions
Why is RC drilling popular in exploration?
It is fast and economical and produces clean chip samples for every metre, allowing many holes to be drilled quickly.
What causes poor RC sample quality?
Wet ground, poor air pressure, worn hammers, dirty cyclones and splitters, and loss of fines can all reduce sample quality.
How deep can RC drill?
Commonly a few hundred metres, depending on rig, compressor capacity and groundwater, though deeper holes are possible with larger rigs.
📡 Request a geophysical survey quote
The cost of a geophysical survey depends mainly on the area or length of survey lines, the methods and depth of investigation needed, and site access. Tell us about your project and we will propose a survey design and quotation.
We reply with a proposed survey design and quotation. Prices are not listed online because every site and target is different.
Plan your geophysical survey
Tell us your site, target and depth of interest. We will recommend the right methods and send a survey design and quotation.