Every decision in exploration, from drilling the next hole to estimating a resource, relies on samples. If samples are not representative, everything built on them is wrong. This article covers sampling techniques and the quality assurance that protects them.
Types of samples
- Rock chip and grab samples: quick, but often biased towards mineralised material.
- Channel samples: continuous cuts across outcrops or trench walls, more representative.
- Soil and stream sediment samples: for geochemical surveys. See geochemical exploration.
- RC samples: chips collected per metre and split.
- Diamond core samples: half or quarter core cut along a marked line.
Principles of good sampling
- Representativeness: the sample must reflect the material sampled.
- Adequate size: especially for coarse gold, larger samples reduce variability.
- Consistency: same method across the project.
- Geological control: sample boundaries match geological changes.
- Documentation: every sample has a unique ID, location and description.
Splitting
RC samples are split with riffle, cone or rotary splitters to a manageable size. Splitters must be clean and level. Core is sawn in half along a consistent line, so both halves have similar mineral content.
Sample preparation
At the laboratory, samples are dried, crushed, split and pulverised to a fine powder. Typical specifications require a high percentage of material to pass set sizes after crushing and pulverising. Preparation errors, such as contamination between samples or poor splitting, can be larger than analytical errors.
Analysis
- Fire assay for gold
- Four-acid or aqua regia digestion with ICP for multi-elements
- Specific methods for high grades and particular elements
Quality assurance
Quality assurance is everything done to make sampling and analysis right the first time:
- Written procedures and trained staff
- Clean equipment and work areas
- Secure, labelled bags and sample registers
- Chain of custody from field to laboratory
- Use of accredited laboratories
Quality control, checking that it worked, uses standards, blanks and duplicates. See QA/QC in mineral exploration.
Sample security
Samples should be stored securely and transported under seal. Documentation should allow every sample to be traced. Security failures can undermine the credibility of an entire project.
Common sampling errors
- Selective sampling of the best-looking material
- Uneven core cutting
- Wet RC samples losing fines
- Contaminated splitters and cyclones
- Mislabelled or swapped bags
How Quantum Geoconsultants can help
We design sampling protocols, train field teams and manage sample flows to laboratories. See mineral exploration and core logging.
Frequently asked questions
What makes a sample representative?
It reflects the true composition of the material it comes from, achieved by correct sampling method, adequate size and careful splitting and preparation.
What is chain of custody?
The documented control of samples from collection to laboratory, ensuring they are not lost, mixed up or tampered with.
Why is sample preparation important?
Crushing, splitting and pulverising reduce samples to the small portion analysed. Errors at this stage can be larger than analytical errors.
📡 Request a geophysical survey quote
The cost of a geophysical survey depends mainly on the area or length of survey lines, the methods and depth of investigation needed, and site access. Tell us about your project and we will propose a survey design and quotation.
We reply with a proposed survey design and quotation. Prices are not listed online because every site and target is different.
Plan your geophysical survey
Tell us your site, target and depth of interest. We will recommend the right methods and send a survey design and quotation.